Home > Manufacturers >

King Kutter Heavy Duty Rotary Cutter
King Kutter Heavy Duty Rotary Cutter


 
Alternative Views:


KING KUTTER HEAVY DUTY ROTARY CUTTERS

King Kutter Heavy Duty Rotary Cutters are designed to meet the needs of any tough job. It is constructed of extra heavy 7 gauge steel, with 8" I-Beam side rails, and a 3/16" single sheet top deck that is fully reinforced with cross and spider bracing, this Heavy Duty Rotary Cutter is built to perform under severe conditions. See blade sizes, and shipping weights in chart below.

Each Rotary Cutter has a splined cast iron gearbox, a shielded PTO shaft with slip clutch, a solid 3/4" thick steel plate blade carrier, heavy duty wheel fork, a top link swivel, and adjustable laminated tail wheel(s).

These Heavy Duty Rotary Cutters are available in 5', 6', and 7' with 60 HP and 80 HP gear boxes available. The 6' and 7' models have dual tail wheels.


  • Add front and rear chains to 60" model for $375
  • Add front and rear chains to 72" model for $399
  • Add front and rear chains to 84" model for $425
  • Free shipping within 1,000 miles!


*Watch Features Video Below



Product Code: KK-HEAVY-DUTY-KUTTER
UNAVAILABLE

Description Extended Information
 
King Kutter Heavy Duty Rotary Cutters. Free shipping within 1,000 miles!
More
King Kutter's Heavy Duty Kutters Specifications

Average Customer Review: Average Customer Review: 4 of 5 4 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
 
3 of 5 bad info October 2, 2019
Reviewer: Thomas Jones from Theodore, AL United States  
web site did not say if cutter was cat I or cat II
I called and asked was told cat I.  cutter was cat II. cutter is very heavy duty.  EA Response:  Sorry for the misinformation.  If someone wishes to convert the cutter to a Category 1, it is as simple as replacing the bolted on lift arm pins.  We will contact customer.

Was this review helpful to you?

  0 of 1 people found the following review helpful:
 
5 of 5 H.D. Mower May 1, 2015
Reviewer: Patrick from Trempealeau, WI United States  
I have used this mower twice, and cut some 1-2" brush with it.   It runs very smoothly and has worked very well.   It seems to be well made and the mower housing is significantly heavier than previous 3 point mowers I have owned.

Was this review helpful to you?